70-24157-03 – INDUCER MOTOR (RHEEM, AFTERMARKET, DIRECT, FB-RFB241)
Aftermarket inducer motor for Rheem/Ruud furnaces. 120V, 3000 RPM, 1/30 HP. Replaces 70-24157-03. Right-side discharge. Complete assembly.
Walk in. We test every part free at the counter. Open to homeowners, contractors, and multifamily — no account or minimum order.
Popular: 45/5 capacitor ECM blower Honeywell ignitor 24V contactor Hard start kit

Ten departments, organized the way our counter is. Every category is on the shelf today.
Bring your old part. We'll diagnose it, find the replacement, and bench-test the new one at the counter before you leave — so you only make one trip.

¿Buscas partes de HVAC en Dallas?
Visita nuestra página en español — mismas partes, mismo mostrador, atendido en español.
Ver página en español →Showing 31–40 of 1617 results

Aftermarket inducer motor for Rheem/Ruud furnaces. 120V, 3000 RPM, 1/30 HP. Replaces 70-24157-03. Right-side discharge. Complete assembly.

Carrier OEM inducer cooling fan wheel. Part 326100-401, also listed as LA660003. Cools the inducer motor during operation. Replace if cracked or wobbling.

Temperature fuse link, opens at 468°F (242°C). 15 Amp rated. One-time-use thermal safety device — if it’s blown, the system overheated and needs the fuse link replaced.

Trane SWT04232 dual furnace pressure switch, -0.17″ and -0.50″ WC. For two-stage Trane/American Standard furnaces. Also replaces SWT02357 and C340789P02.

3/8″ sweat liquid line filter drier, 16 cu. in., uni-flow. Removes moisture and acid from the refrigerant line. Works with R-22, R-410A, and other common refrigerants.

120V condensate pump with built-in overflow safety switch. Pumps condensate away from your AC or furnace when gravity drain isn’t possible. Standard 120V plug-in.

24V SPST heat sequencer (1 switch). Supco Q102. Longer delay timing than Q101. Controls one heating element or blower in electric furnaces.

High-temperature limit switch for Goodman/Amana equipment, recorded as a disc-type switch with a deep back and an L120 degree F opening point.

16-inch ductboard triangle made from insulated fiberboard. Used to form 90-degree turns and transitions in ductboard systems. Fits standard 16″ duct runs.

2.5″ aluminum foil tape for HVAC duct sealing. UV and moisture resistant. Sticks to metal ductwork for airtight seals at joints and seams.