RG1608 – RETURN GRILLE (16″W x 8″T)
16″W x 8″T return air grille with fixed louver blades. White powder-coated steel. Mounts on wall or ceiling over your return duct opening.
Walk in. We test every part free at the counter. Open to homeowners, contractors, and multifamily — no account or minimum order.
Popular: 45/5 capacitor ECM blower Honeywell ignitor 24V contactor Hard start kit

Ten departments, organized the way our counter is. Every category is on the shelf today.
Bring your old part. We'll diagnose it, find the replacement, and bench-test the new one at the counter before you leave — so you only make one trip.

¿Buscas partes de HVAC en Dallas?
Visita nuestra página en español — mismas partes, mismo mostrador, atendido en español.
Ver página en español →Showing 571–580 of 1291 results

16″W x 8″T return air grille with fixed louver blades. White powder-coated steel. Mounts on wall or ceiling over your return duct opening.

Carrier OEM inducer cooling fan wheel. Part 326100-401, also listed as LA660003. Cools the inducer motor during operation. Replace if cracked or wobbling.

Supco BPV31 Bullet piercing valve for 1/4″, 5/16″, and 3/8″ OD tubing. Clamps onto sealed lines to add a service access port — no brazing needed. Patented gasket seal.

Three-pole 40A contactor with 120V coil (C340B/DP401203). For 3-phase AC and commercial HVAC applications. Silver cadmium oxide contacts by Supco.

10″ x 6″ clockwise blower wheel with convex blades and 1/2″ bore. OEM Goodman part. Replaces Carrier LA22RA101 and Lennox WHL00740.

Carrier HH12ZB160 high limit switch, 3-inch insertion, opens at 160°F. Auto reset. Crosses to Trane SWT01257. For Carrier, Bryant, Payne, and Trane furnaces.

Insulated return air box, 20×20 opening with ductboard top. Connects return grilles to round ductwork — cut the top on-site to match your duct size. Galvanized steel.

20/8 thermostat wire, 125-foot roll. Eight conductors, lighter 20-gauge for shorter runs. Good for heat pump and multi-stage systems. Southwire brand.

Galvanized duct reducer, 7″ to 6″. Transitions between two different round duct sizes in a supply or return run. Crimped end for easy connection.

16″W x 25″T return air filter grille. Holds a standard 1″ filter. Removable hinged face for easy filter changes. White steel, mounts on wall or ceiling.