Walk in. We test every part free at the counter. Open to homeowners, contractors, and multifamily — no account or minimum order.
Popular: 45/5 capacitor ECM blower Honeywell ignitor 24V contactor Hard start kit
Ten departments, organized the way our counter is. Every category is on the shelf today.
Bring your old part. We'll diagnose it, find the replacement, and bench-test the new one at the counter before you leave — so you only make one trip.
¿Buscas partes de HVAC en Dallas?
Visita nuestra página en español — mismas partes, mismo mostrador, atendido en español.
Ver página en español →Showing 1111–1120 of 1617 results
Lennox / Allied Air ECB45-series electric heat section, 15 kW at 208/240V single phase, 60 Hz, with factory-installed circuit breaker protection (one 60 A and one 25 A breaker). Lennox lists it for CBK45 and CBA25 series air handlers.
Three-pole 40A contactor with 24V coil (C340A/DP40243). For 3-phase commercial AC and refrigeration. Silver cadmium oxide contacts by Supco.
Ceramic temperature fuse link (straight), opens at 333°F (167°C). 15 Amp. Ceramic body for higher heat environments. Straight terminal orientation.
DiversiTech ESP Rhino tank carrier and compressor tote – a carry frame for moving refrigerant cylinders and compressors around a jobsite.
45+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly TrueLine replacement for residential AC.
Yellow Jacket 19109 SealRight 1/4″ straight low-loss fitting. Traps refrigerant automatically when you disconnect. Male flare, straight design.
Supco SSN24 hot surface ignitor and flame sensor combo. 24 VAC. Direct replacement for Honeywell Q3400A1024 Smart Valve systems.
Braeburn replacement supply air (discharge air) temperature sensor for Braeburn zoning systems.
DiversiTech Term-LOK three-wire, 10 gauge compressor connection kit. Simplifies repair of burned or damaged spade terminals when reconnecting or replacing a compressor, and fits both burned and non-burned terminals.
40oz tinning hammer with polished striking face and wooden handle. Built for bending, seaming, and forming sheet metal ductwork in HVAC installations.