BOOT1489 – INSULATED REGISTER BOOT (14X8-9)

A register boot connects your round ductwork to a rectangular floor or wall register. If you’re adding a new vent run, replacing a damaged boot, or finishing a room addition, this is the transition piece you need. The 14×8 size handles higher airflow for larger rooms. Internal insulation cuts down on condensation and duct noise.

Specs: 14″ x 8″ register opening, 9″ round duct collar, galvanized steel, internally insulated

Replaces: BOOT1489

Fits: Standard 14×8 floor and wall registers with 9″ round duct runs. Works with all major HVAC brands.

In stock at Open To Public HVAC Parts in Dallas. We test parts at the counter before you buy. Call or text (214) 340-9421.

Specs

• TypeInsulated register boot
• Grille size14"W x 8"H
• Duct collar9" round
• InsulationInternally insulated
• SizingBox dimension first, then the duct opening

Cross-reference numbers

This part replaces the following OEM and aftermarket numbers:

• BOOT1489
• SOUTHWARK14X8

Not sure if your number matches? Call (214) 340-9421 or bring the old part in — bench-testing is free.

Fits these models

• IMPERIAL14X8BOOT

How are register boots sized?

Box dimension first, then the duct opening. The first two numbers are the grille size in inches - width by height - and the third is the round duct hole. A boot listed 12x6-7 has a 12 by 6 grille size and a 7 inch duct hole on top.

Which number is width and which is height?

Width first, then height, the same convention as the register itself. Getting them backwards is the usual reason a boot comes back.

What size duct hole do I need?

Match the duct run feeding it. Do not neck an 8 inch run down to a smaller boot collar to make it fit - you get noise at the register and lose air in that room.

Are these insulated?

All of our register boots are INTERNALLY insulated - the insulation is inside the boot rather than wrapped around the outside, so the sheet metal does not sweat where the boot sits in an attic or a crawl space. In Dallas that covers most installs. The square boxes - 10x10x10, 12x12x12 and 14x14x14 - are uninsulated and are meant for use inside conditioned space.

What is a no-hole boot for?

It comes with no duct opening cut, so you cut the collar in wherever the run actually approaches - side, end or top. Useful in tight framing where a factory hole would land in the wrong place. You add your own collar.

What is a return air box?

A larger box that sits behind a return grille, usually with a duct board top, giving the return duct somewhere to land and the grille something to screw to. Sized to the return grille it serves.

Do you stock my size?

We keep common residential boot and return box sizes on the shelf at 10226 Plano Rd, Suite 104 in Dallas. Bring the register size and the duct size.