0130F00008 – IGNITOR (GOODMAN, AFTERMARKET, DIRECT, SSN084KS)
Silicon nitride ignitor for Goodman/Amana furnaces. 120V. Replaces 0130F00008. Direct replacement — no modification needed.
Showing 1–48 of 100 results

Silicon nitride ignitor for Goodman/Amana furnaces. 120V. Replaces 0130F00008. Direct replacement — no modification needed.

12.5 MFD 440V oval run capacitor. Powers a single motor — usually the condenser fan. Budget-friendly TrueLine replacement for any 12.5 MFD oval cap.

Silicon nitride ignitor for Lennox furnaces. 95V. Replaces 19W61. Direct replacement SSN21 — no modification needed.

25+7.5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

Aftermarket inducer motor for Carrier furnaces. 115V, 1/25 HP, 3300 RPM. Replaces 318984-753, HC21ZE114, HC21ZE117, and HC21ZE123. Fits a wide range of Carrier models.

Silicon nitride ignitor for Carrier/Bryant furnaces. 120V. Replaces 332505-751 and LH33ZG001. Direct replacement SSN086KS.

35+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

Three-pole 40A contactor with 120V coil (C340B/DP401203). For 3-phase AC and commercial HVAC applications. Silver cadmium oxide contacts by Supco.

Three-pole 40A contactor with 240V coil (C340C/DP402403). For 3-phase AC and commercial HVAC applications. Silver cadmium oxide contacts by Supco.

Three-pole 40A contactor with 24V coil (C340A/DP40243). For 3-phase commercial AC and refrigeration. Silver cadmium oxide contacts by Supco.

Supco 3W1 hard start kit for 1-3 ton compressors. 3-wire design with potential relay and start capacitor. Gets stubborn compressors running on hot days.

Supco 3W2 hard start kit for 3.5-5 ton compressors. 3-wire design with potential relay and start capacitor. Built for larger residential and light commercial AC.

Supco 3W3 hard start kit for 4-5 ton compressors. 3-wire design with potential relay and start capacitor. Heavy-duty option for the largest residential systems.

Supco 43004A mechanical thermostat. Horizontal mount. For 4 or 5-wire 24V systems and single-stage heat pumps. Adjustable heat anticipator. No batteries needed.

50+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

Lennox 51M14 flame sensor, single-prong design. Aftermarket direct replacement for multiple Lennox furnace models. Also listed as FLS51M14.

Lennox 52W29 flame sensor kit with straight probe. Aftermarket direct replacement for Lennox furnaces. Also listed as FLS52W29.

55+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

5 MFD 440V oval run capacitor. Powers a single motor — usually the condenser fan. Budget-friendly Supco replacement for any 5 MFD oval cap.

70+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

70+5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

80+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

80+5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.

First Company 9-115-34-1 thermal fuse link assembly. 25 Amp, opens at 300°F. Ceramic body with stake-on terminals. Safety device for First Company HX coil units.

Supco AT012 adjustable disc limit switch, 135°F to 175°F range. SPST open-on-rise. Crosses to E144 and PT012. Universal fit for furnaces and heating equipment.

Supco AT013 adjustable disc limit switch, 175°F to 215°F range. SPST open-on-rise. Crosses to Nordyne 626487R and PT013. Universal fit for furnaces.

Supco ATP1 Attic Pro utility lift. Safely lifts up to 250 lbs into attics or elevated spaces. 20 ft cable with adjustable length and locking hook. One-person operation.

Goodman B1370738 fan switching relay/sequencer (Q108 aftermarket). 24V SPDT. Controls the blower fan timing in Goodman and Amana furnaces.

Supco BPV21 Bullet piercing valve for 1/2″ and 5/8″ OD tubing. Clamps onto sealed lines to add a service access port — no brazing needed. Patented gasket seal.

Supco BPV31 Bullet piercing valve for 1/4″, 5/16″, and 3/8″ OD tubing. Clamps onto sealed lines to add a service access port — no brazing needed. Patented gasket seal.

Supco BRK3 resettable 3 Amp diagnostic fuse for HVAC low-voltage circuits. Built-in light shows when circuit is active. Resets instead of blowing — saves time troubleshooting.

Supco BRK5 resettable 5 Amp diagnostic fuse for HVAC low-voltage circuits. Built-in light shows circuit activity. Trips and resets without blowing — great for troubleshooting.

DiversiTech CO-1 Zoom Spout lubricating oil, 4 oz. Telescoping spout extends up to 14 inches for hard-to-reach spots. General-purpose lubricant for HVAC and mechanical work.

Supco FCR6 fin comb ring set — 6 color-coded combs for 8 to 20 fins per inch. Straightens bent condenser and evaporator coil fins to restore airflow.

Supco FSC10 flame sensor cleaner. Compact, durable tool cleans flame sensor rods in seconds. Fixes the most common cause of furnace short-cycling.

3/8″ sweat bi-flow filter drier, 16 cu. in. Works in both directions — made for heat pump systems. Removes moisture and acid. Compatible with all common refrigerants.

24V SPST heat sequencer (1 switch). Supco Q101. Basic single-stage sequencer for electric furnaces. Controls one heating element or blower.

24V SPST heat sequencer (1 switch). Supco Q102. Longer delay timing than Q101. Controls one heating element or blower in electric furnaces.

24V DPDT heat sequencer (2 switches). Supco Q103. Controls a heating element and a blower motor on timed delays. Replaces 24A34-3.

24V DPDT heat sequencer (2 switches). Supco Q104. Different delay timing than Q103. Replaces HS24A344, Emerson E143, and NS104.

Supco IG409 hot surface ignitor for Carrier furnaces. Silicon carbide. Direct replacement for 767A-370 and LH33ZS004.

Supco IG418 hot surface ignitor for Goodman, Trane, and Rheem furnaces. Silicon carbide. Replaces B1401015 and 767A-372.

Silicon nitride ignitor for Trane/American Standard furnaces. 120V. Replaces IGN00152 and IGN00146. Direct replacement SSN087KS.

Supco JV1 condensate cleanout valve. Installs inline on 3/4″ drain lines — open it to flush the line or attach a drain gun. Easy maintenance access point.

Supco SKIT3033 hot surface ignitor for Trane furnaces. Silicon carbide. Direct replacement for Trane KIT03033.

Carrier flame sensor replacement (LH680534). Aftermarket direct fit with 73-degree bend and Kanthal rod. Replaces LH33WZ515, LH33WZ517, LH33WZ521, and more.

1/4″ threaded liquid line drier for refrigerant recovery machines. Solid core design removes moisture and acid. Compatible with all refrigerants.

Supco MAG1YL magnetic jumper wire, 20 inches. Magnetic tips clip to terminals for hands-free HVAC diagnostics. Rated 30 VAC/VDC, 5 amps. Yellow wire.