0130F00008 – IGNITOR (GOODMAN, AFTERMARKET, DIRECT, SSN084KS)
$63.21Silicon nitride ignitor for Goodman/Amana furnaces. 120V. Replaces 0130F00008. Direct replacement — no modification needed.
Showing 1–48 of 86 results
-
-
12.5X440 – CAPACITOR (OVAL, MADE OVERSEAS)
$12.1012.5 MFD 440V oval run capacitor. Powers a single motor — usually the condenser fan. Budget-friendly TrueLine replacement for any 12.5 MFD oval cap.
-
25+7.5X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$29.5625+7.5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
318984-753 – INDUCER MOTOR (CARRIER, AFTERMARKET, DIRECT, SM4753)
$95.50Aftermarket inducer motor for Carrier furnaces. 115V, 1/25 HP, 3300 RPM. Replaces 318984-753, HC21ZE114, HC21ZE117, and HC21ZE123. Fits a wide range of Carrier models.
-
332505-751 – IGNITOR (CARRIER, AFTERMARKET, DIRECT, SSN086KS)
$63.21Silicon nitride ignitor for Carrier/Bryant furnaces. 120V. Replaces 332505-751 and LH33ZG001. Direct replacement SSN086KS.
-
35+10X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$29.7635+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
3P40A120V – CONTACTOR (3 POLE, 40 RLA, 120V COIL)
$35.95Three-pole 40A contactor with 120V coil (C340B/DP401203). For 3-phase AC and commercial HVAC applications. Silver cadmium oxide contacts by Supco.
-
3P40A24V – CONTACTOR (3 POLE, 40 RLA, 24V COIL)
$39.43Three-pole 40A contactor with 24V coil (C340A/DP40243). For 3-phase commercial AC and refrigeration. Silver cadmium oxide contacts by Supco.
-
3W1 – HARD START KIT (3 WIRE, 1-3 TON)
$41.20Supco 3W1 hard start kit for 1-3 ton compressors. 3-wire design with potential relay and start capacitor. Gets stubborn compressors running on hot days.
-
3W2 – HARD START KIT (3 WIRE, 3.5-5 TON)
$48.09Supco 3W2 hard start kit for 3.5-5 ton compressors. 3-wire design with potential relay and start capacitor. Built for larger residential and light commercial AC.
-
43004A – MECHANICAL THERMOSTAT (HORIZONTAL)
$38.99Supco 43004A mechanical thermostat. Horizontal mount. For 4 or 5-wire 24V systems and single-stage heat pumps. Adjustable heat anticipator. No batteries needed.
-
50+10X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$31.4150+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
51M14 – FLAME SENSOR (LENNOX, AFTERMARKET, DIRECT, FLS51M14)
$23.18Lennox 51M14 flame sensor, single-prong design. Aftermarket direct replacement for multiple Lennox furnace models. Also listed as FLS51M14.
-
52W29 – FLAME SENSOR (LENNOX, AFTERMARKET, DIRECT, FLS52W29)
$23.18Lennox 52W29 flame sensor kit with straight probe. Aftermarket direct replacement for Lennox furnaces. Also listed as FLS52W29.
-
55+10X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$33.2755+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
5X440 – CAPACITOR (OVAL, MADE OVERSEAS)
$11.315 MFD 440V oval run capacitor. Powers a single motor — usually the condenser fan. Budget-friendly Supco replacement for any 5 MFD oval cap.
-
70+10X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$33.9670+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
70+5X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$33.5370+5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
80+10X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$35.2680+10 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
80+5X440 – DUAL CAPACITOR (ROUND, MADE OVERSEAS)
$34.2080+5 MFD 440V dual run capacitor. Powers both the compressor and condenser fan motor. Budget-friendly Supco replacement for residential AC.
-
9-115-34-1 – FUSE LINK ASSEMBLY (FIRST CO, N951-1)
$11.84First Company 9-115-34-1 thermal fuse link assembly. 25 Amp, opens at 300°F. Ceramic body with stake-on terminals. Safety device for First Company HX coil units.
-
AT012 – ADJUSTABLE DISC LIMIT SWITCH (135° to 175°)
$22.91Supco AT012 adjustable disc limit switch, 135°F to 175°F range. SPST open-on-rise. Crosses to E144 and PT012. Universal fit for furnaces and heating equipment.
-
AT013 – ADJUSTABLE DISC LIMIT SWITCH (175° to 215°)
$22.91Supco AT013 adjustable disc limit switch, 175°F to 215°F range. SPST open-on-rise. Crosses to Nordyne 626487R and PT013. Universal fit for furnaces.
-
B1370738 – FAN SWITCHING RELAY/SEQUENCER (GOODMAN, AFTERMARKET, DIRECT, Q108)
$32.60Goodman B1370738 fan switching relay/sequencer (Q108 aftermarket). 24V SPDT. Controls the blower fan timing in Goodman and Amana furnaces.
-
BPV31 – PIERCING VALVE (1/4″, 5/16″, 3/8″)
$8.11Supco BPV31 Bullet piercing valve for 1/4″, 5/16″, and 3/8″ OD tubing. Clamps onto sealed lines to add a service access port — no brazing needed. Patented gasket seal.
-
BRK3 – RESETABLE FUSE (3 AMP)
$21.66Supco BRK3 resettable 3 Amp diagnostic fuse for HVAC low-voltage circuits. Built-in light shows when circuit is active. Resets instead of blowing — saves time troubleshooting.
-
BRK5 – RESETABLE FUSE (5 AMP)
$21.66Supco BRK5 resettable 5 Amp diagnostic fuse for HVAC low-voltage circuits. Built-in light shows circuit activity. Trips and resets without blowing — great for troubleshooting.
-
CO-1 – ZOOM SPOUT LUBRICATING OIL (4 OZ)
$8.78DiversiTech CO-1 Zoom Spout lubricating oil, 4 oz. Telescoping spout extends up to 14 inches for hard-to-reach spots. General-purpose lubricant for HVAC and mechanical work.
-
HP163S – BI-FLOW REFRIGERANT DRIER (3/8″, SWEAT, 16 CU.IN.)
$23.783/8″ sweat bi-flow filter drier, 16 cu. in. Works in both directions — made for heat pump systems. Removes moisture and acid. Compatible with all common refrigerants.
-
HS1P1S – HEAT SEQUENCER (SPST, Q101)
$27.3524V SPST heat sequencer (1 switch). Supco Q101. Basic single-stage sequencer for electric furnaces. Controls one heating element or blower.
-
HS1P2S – HEAT SEQUENCER (SPST, Q102)
$28.4024V SPST heat sequencer (1 switch). Supco Q102. Longer delay timing than Q101. Controls one heating element or blower in electric furnaces.
-
HS2P1S – HEAT SEQUENCER (DPDT, Q103)
$29.4524V DPDT heat sequencer (2 switches). Supco Q103. Controls a heating element and a blower motor on timed delays. Replaces 24A34-3.
-
HS2P2S – HEAT SEQUENCER (DPDT, Q104)
$29.4524V DPDT heat sequencer (2 switches). Supco Q104. Different delay timing than Q103. Replaces HS24A344, Emerson E143, and NS104.
-
IG409 – HOT SURFACE IGNITOR (CARRIER)
$37.66Supco IG409 hot surface ignitor for Carrier furnaces. Silicon carbide. Direct replacement for 767A-370 and LH33ZS004.
-
IG418 – HOT SURFACE IGNITOR (GOODMAN, TRANE, RHEEM)
$37.66Supco IG418 hot surface ignitor for Goodman, Trane, and Rheem furnaces. Silicon carbide. Replaces B1401015 and 767A-372.
-
IGN00152 – HOT SURFACE IGNITOR (TRANE, AFTERMARKET, DIRECT, SSN087KS)
$63.21Silicon nitride ignitor for Trane/American Standard furnaces. 120V. Replaces IGN00152 and IGN00146. Direct replacement SSN087KS.
-
JV1 – CONDENSATE CLEANOUT VALVE
$17.99Supco JV1 condensate cleanout valve. Installs inline on 3/4″ drain lines — open it to flush the line or attach a drain gun. Easy maintenance access point.
-
KIT03033 – IGNITOR (TRANE, AFTERMARKET, DIRECT, SKIT03033)
$56.38Supco SKIT3033 hot surface ignitor for Trane furnaces. Silicon carbide. Direct replacement for Trane KIT03033.
-
LH680534 – FLAME SENSOR (CARRIER, AFTERMARKET, DIRECT, FLS014)
$23.44Carrier flame sensor replacement (LH680534). Aftermarket direct fit with 73-degree bend and Kanthal rod. Replaces LH33WZ515, LH33WZ517, LH33WZ521, and more.
-
LLD032 – REFRIGERANT DRIER (RECOVERY MACHINE, 1/4″ THREADED)
$16.891/4″ threaded liquid line drier for refrigerant recovery machines. Solid core design removes moisture and acid. Compatible with all refrigerants.
-
MAG1YL – MAGNETIC LOW VOLTAGE JUMPER WIRE
$14.95Supco MAG1YL magnetic jumper wire, 20 inches. Magnetic tips clip to terminals for hands-free HVAC diagnostics. Rated 30 VAC/VDC, 5 amps. Yellow wire.
-
MB55 – BRACKET (3 ARM FLEXIBLE)
$23.443-arm flexible motor bracket for 5.5″ diameter blower motors up to 1/2 HP. Supco MB55. Reduces vibration and noise. Includes hardware.
-
MB554 – BRACKET (4 ARM FLEXIBLE)
$29.454-arm flexible motor bracket for motors up to 5-5/8″ diameter and 1/2 HP. Supco MB554. Extra stability with 4 mounting points. Includes hardware.
-
RCB1 – REFRIGERATION COIL BRUSH
$8.69Supco RCB1 refrigeration coil brush, 27.5″ long with dual bristle lengths. Cleans between condenser and evaporator coil fins. Wooden handle.
-
S1-02527773700 – FLAME SENSOR (YORK, AFTERMARKET, DIRECT, FLS700)
$23.44York flame sensor replacement (S1-02527773700). Aftermarket direct fit with 4-inch probe and Kanthal rod. Fits York, Coleman, and Luxaire furnaces.
-
SF3813 – VALVE CORE TOOL W/ CORES
$9.91Supco SF3813 valve core tool with 3 replacement cores. 3-inch all-brass body with textured grip. Removes and installs Schrader valve cores on AC service ports.
-
SF8408 – STINGER
$4.03Supco SF8408 Stinger line service valve. 1/8″ OD with 2″ copper tubing extension and plain cap. Braze-on access point for small refrigerant lines.
-
SFL1402 – PLASTIC LOCKING VALVE CAPS – 2 PACK (MEETS CODE REQUIREMENT)
$18.20Supco SFL1402 safety locking valve caps, 2-pack. 1/4″ thermoplastic caps that lock onto refrigerant access valves. Meets code requirements for tamper-resistant caps.
